Comments on: Ground Pour

By: LC

LC — Sat, 05 Feb 2011 06:11:00 +0000

Why does only the “square” package show up for every device in the supply library? Did I do something wrong?

By: Tony

Tony — Sat, 27 Nov 2010 18:16:41 +0000

could you change c4 or c1 to filter out some treble or simulate rolling your treble knob on your guitar back as I have had no luck wiring in a treble control in this circuit and I like with the treble all yhe way off

By: John

John — Thu, 02 Sep 2010 21:49:41 +0000

Parker-

A ‘mil’ is 0.001 inches.
I’ve seen lots of people mistake it as an abbreviation for millimeter, however
1 mil = 0.0254 millimeters

By: paijo

paijo — Fri, 11 Jun 2010 06:55:22 +0000

this is what i need…thanks

By: Hawg

Hawg — Tue, 08 Jun 2010 17:48:56 +0000

gm-

I also got the error when I entered the ch lay bot command, because I was still working from the new->schematic from the last tutorial.

If anyone else gets the error, it might be because you are working on a schematic instead of a board. Right click your project and go new ->board.

By: Parker

Parker — Tue, 09 Mar 2010 16:40:58 +0000

Ah sorry my mistake I was assuming ‘mil’ was short for ‘millimetres’ which apparently it isnt? Must be a yank thing…
Again this is a fantastic tutorial – cheers

By: Parker

Parker — Mon, 08 Mar 2010 19:26:27 +0000

Great tutorial, but what do those six commands actually do? Becasue now eagle thinks my board is actually 3.7 metres across and I cant seem to change it back…

By: RNFR

RNFR — Sat, 07 Nov 2009 18:57:24 +0000

i’ve found that ch wid 1 makes your ground pour edged much cleaner and nicer looking. give it a shot!

and thanks GM, i still refer here often!

By: Anonymous

Anonymous — Sat, 12 Sep 2009 20:29:32 +0000

nice ..

By: Anonymous

Anonymous — Sat, 12 Sep 2009 20:29:01 +0000

good tuto